Fabric Down-Proof Impact Tester
Introduction
The first sample is made of bags which built a certain quality of the down. The sample bag is placed on the slope, and the impact needle fixed to the movable plate is reciprocated with the movable plate, and the specimen is subjected to compression shock at the same time. Repeat the operation to a certain number of shocks to stop the test.
Applications
The instrument uses the impact method to determine the fabric anti-drilling performance, suitable for testing all kinds of down products, such as duvets, down jacket and so on.
The fabric to be measured is made into a cylindrical bag containing feathers, feathers or a mixture thereof.
The sample bag is placed on the slope, and the impact needle fixed to the movable plate is reciprocated with the movable plate, and the specimen is subjected to compression shock at the same time. Repeat the operation to a certain number of shocks to stop the test.
Standards
BS EN 12132-2：Feather and down - Methods of testing the down-proof properties of fabrics - Impact test
Features
i.Steel frame structure is firm and stable;
ii.The impact equipment consists of two plates. One is a fixed plate whose center fixes a impact pin. The other is the movable board, which fixes three impact pins;
iii.The lower impact plate has three fixed-mounted impactors with an angle of 120 ° and a distance of 95 mm. Impact rod length of 80mm, diameter of 15mm, the top is round;
iv.The impact frequency of the movable plate was controlled by 35 times / min using a crank joystick mechanism;
v.The counter has a preset number of revolutions and full turn stop function.
Другие товары поставщика
|
|
PV Hail Impact Tester |
Standard Compliance
IEC 61215: Mechanical load testing for terrestrial photovoltaic modules.
UL 61730: Safety standards for photovoltaic modules ... |
|
|
Rain Tester |
Standard
AATCC 35: Water Resistance: Rain Test for Fabrics
BS EN ISO 22958: Textiles – Determination of Resistance to Water Penetration &nd... |
|
|
Helmet Strap Tensile meter |
Purpose
Apply a certain initial load to the helmet strap system for a certain period of time. Then, let a weight of a certain mass fall from a cer... |
|
|
Floor Caster Wear chamber |
Meet the standard:
GB/T 11982.2.
GB/T 4085.
BS/EN 425.
ISO 4918-2009
ASTM D6962
BS EN 425-2002
BS EN 985-2001
ISO 10581-2011
ANSI-NALFA-LF... |
|
|
Vacuum Environment Ball-on-Disk Tribometer |
Standards
ASTMD4172-94
ASTMD2266-91
SH/T0189-92
Main Purposes
The vacuum ball - disk friction tester is a device specifically used for evaluat... |
Все товары поставщика
Похожие товары
