Alnico Magnets
Cast Alnico 5 is the most commonly used of all the cast Alnico magnets. This material is used extensively in rotating machinery, meters, instruments, sensing devices, and holding applications, to name a few. Alnico is hard and brittle. cannot be Machined or drilled. therefore be accomplished by ordinary methods. Holes are usually cored in at the foundry, and magnets are cast close to final size and then finish grinded to close tolerances.
Other supplier products
|
CoFeVCr |
Characteristics and Performance of FeCrCo Magnets Characteristics: Has similar Alnico5 magnets performance. Can be machined by drilling, milling, g... |
|
NdFeB Magnets |
Bonded NdFeB magnets are produced by binding rapid-quenching Nd-Fe-B powders which is mixed with plastic resin to form a magnet by compression mold... |
|
Magnets |
Our magnetic products: Magnets and pickups do not have sounds, a manget's sonic result in guitar pickups application depends primarily on the stren... |
|
Cast Alnico Alcomax3 |
AlNiCo permanent magnets have been made from alloys of aluminum, nickel and cobalt with iron. Alnico and alcomax are two of the trade names of such... |
|
Ceramic |
Hard Ferrite (ceramic) magnets, composed of barium or strontium, were developed in the early 1960's as an alternative to the more expensive metalli... |
供应产品
Same products