10a 12v/24v waterproof IP67 solar charge controller with output current canstant

Phenomenon

Causes and solutions

When there is sun rays irradiating at solar panels LED indicator (1) don't work

Check the if connection of solar panels and this controller is correct like if there is reverse connection of anode and cathode even if there is disconnect of terminals;

Solar panel indicator (1) flashes fast;

System is in the stage of over voltage; there is disconnection between battery and solar panels even final loads , check if the charge circle is in right connection.

Load indicator (3) working normally but there is no output;

Check if the connection of loads and controller is in the right method

Battery indicator turns red and there is no output-loads don't work;

Battery is in the stage of over charge , charge the battery again to reuse

Model

SDL-SF60W constant solar charge controller

System voltage

12V; 24V;

Power output

12V≤30W 24V≤60W

Voltage output

(Vin+5V)~60V

Voltage distortion range

+/-600mV

Output current

≤1.2A

Current output accuracy

<2%

Normal efficiency

90%

Normal working temperature range

-30°C— +65°C

No load working current consumption

≤10 mA

Inner charge circuit voltage drop

≤ 0.26V

Inner discharge circuit voltage drop

≤ 0.15V

Over voltage protection

17V,×2/24V;

Boost charge voltage

14.6V;×2/24V; (10 minutes duration and only occurs when over-discharge happens)

Direct charge voltage

14.4V;×2/24V; (10min duration)

Float charge voltage

13.6V;×2/24V;(Charging Voltage duration will last until the voltage turn to the returned voltage point )

Returned voltage after charging

13.2v; ×2/24V;

Temperature compensation

-5mv/°C;

Under voltage

12.0V; ×2/24V;

Over discharge voltage

11.1V-; ×2/24V;

Returned voltage point after charging from last over-discharge

12.6V;×2/24V;

Working principle

PWM charging mode