L0750T Export standard duct rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
|
Stripper for high voltage cable |
1.tungsten steel blade,hard and sharp. 2.Can cut the smooth degree of slope. 3.For cutting out the standard of thick wide angle,diameter of the cab... |
|
|
HZ-85 Safety Hydraulic Cable Cutter |
FEATURE 1.Flip top cutting head rotates 350o 2.Two stage hydraulic to reduce cutting cycle, automatic release pressure when cut is completly stop ... |
|
|
Wire Cable L0410 Running Rod Duct Rodder Fishtape Puller 4.5mm |
The intensity of traction, flexibility, anti-aging, heat resistance, resistance to acid and alkali degree are considerably more than 1 or 2 generat... |
|
|
Underground Cable Roller |
Detailed Description Used in the cable changing the direction place protection cable not to wear. Features Divides into according to the material q... |
|
|
TC-38 Manual safety cable cutter Tool |
Features: 1.Strong,light weight glass fiber handle. 2.Adjustable pivot bolt realized adjustable blade. 3.Changeable,forging blade heat treated and ... |
Все товары поставщика
Похожие товары
