L06S30 ECO Fishtape Puller
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
|
SKG-50N anti-twist rope wire grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
|
|
Electric grinder |
cable winch is composed of a roller wheel, gearbox, diesel or gasoline machine and a base frame, the mobile cutter grinding principle: cutter grind... |
|
|
Wire Cable L0410 Running Rod Duct Rodder Fishtape Puller 4.5mm |
Purpose: Cable puller is mainly used for in building installation wiring duct drawing guide line, as well as the protection communication cable, po... |
|
|
cable jacks distance between two rails adjustable |
Purpose: applicable to the line of the line construction in the development and release of the disc Features: the exhibition release speed is stabl... |
|
|
electric transmission line cable winch |
cable winch is composed of a roller wheel, gearbox, diesel or gasoline machine and a base frame, the mobile cutter grinding principle: cutter grind... |
Все товары поставщика
Похожие товары
