W0830 fish type three braid
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
|
Cable Drum Rotators - Heavy Duty |
Purpose: applicable to the line of the line construction in the development and release of the disc Features: the exhibition release speed is stabl... |
|
|
Fibreglass rodder duct fish snake cable puller 4.5mm x 100 mtrs |
Fiberglass duct rodder features 1.Light weight,durable,resistance to acid,alkali,aging resistant,corrosion resistant. 2.High tensile strength and b... |
|
|
T50 pipe diameter 1/2” |
1.Made of steel wire rope 2.Density: 8（g/m） 3.Rod diameter 2（mm） 4.Temperature - 800 to 800 (℃) 5.Traction tension failure 800（kg） Operation: 1.B... |
|
|
stringing tools-cable winch |
It mainly consists of two motor, one reduction box traction head and up frame, etc. It not only applied for traction power cable, communication cab... |
|
|
split wire mesh grip |
Cable Grips are a quick, efficient way to install/control electrical or heavy-duty cables. Cable Grips are re-usable (subject to inspection) and ca... |
Все товары поставщика
Похожие товары
