L06S50 50M/6mm High strong Duct Rodders
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
|
L0420 cable access kit 4.5x200mm fiberglass push pull rod cable puller |
Purpose: Cable puller is mainly used for in building installation wiring duct drawing guide line, as well as the protection communication cable, po... |
|
|
cable traction machine, cable winch |
cable winch is composed of a roller wheel, gearbox, diesel or gasoline machine and a base frame, the mobile cutter grinding principle: cutter grind... |
|
|
SD-1000C all purpose wire grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
|
|
L06S10 wall Tracing Duct Rod |
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secon... |
|
|
Hydraulic cable drum jack,Cable drum trestles,Hydraulic lifting jacks |
Features It is applicable to be as the support of large cable reel in laying cables in the city. It is easy to move with the trundles in the bottom... |
Все товары поставщика
Похожие товары
