L06S30 CBRL cable puller
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
HX-120B the best-selling mechanical crimping pliers |
The above is my company product information about the crimping pliers, in addition, our company also produces cable cutters, crimping machine, card... |
|
3T,5T ,8T,10T,12T Payload Cable Drum Trailer |
It mainly consists of two motor, one reduction box traction head and up frame, etc. It not only applied for traction power cable, communication cab... |
|
Supply Series Of Fiberglass 250M/16mm High strong FRP Duct Rodders |
A braided wrap of reinforcing fibers increases its rigidity and helps bond the core with the outer plastic coating. The coating is made from a poly... |
|
Supply a large number of inventory Glass fiber reinforced plastic cleaning rod |
Outer protect layer are made of high density polyethylene engineering plastic, which has good anti-UV capability. Cover was coated with long-term U... |
|
T50 easy to opperate / quick pulling wire |
1.Made of steel wire rope 2.Density: 8(g/m) 3.Rod diameter 2(mm) 4.Temperature - 800 to 800 (℃) 5.Traction tension failure 800(kg) |
Все товары поставщика
Похожие товары