FHT-300/400G split type hydraulic clamp crimping tool
when using the surface pressure molding department not to rust, damage and dirt. Crimping pliers, if in the case of die residual metal debris still use it, may result in incomplete or pressure to failure.
Другие товары поставщика
|
|
cable access kit 10x330mm fiberglass push pull rod cable puller |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
|
|
L0420 fiberglass push pull rod for NBN telcom fish tape |
Purpose: Cable puller is mainly used for in building installation wiring duct drawing guide line, as well as the protection communication cable, po... |
|
|
TC-500B iron bar hand cable cutter |
TC-500B hand Cutter for steel wire/iron bar/copper wire The handle is made of high tensive aluminum alloy, the knives are made by forging, long lif... |
|
|
W0850T fish type obdurability |
then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold... |
|
|
belt drive or shaft drive, cable winch |
The use of ground grinding security technology (1) the ground should be put on the flat, accessibility, and fixed tightly, prevent the ground plan... |
Все товары поставщика
Похожие товары