Steel Bloom

• 

Description of steelbloom

Usually, during hot rolling, the bloom is a semi-finished nearly square solid metal form between the ingot and the billet. The cross-section of the steel slabbloom is usually greater than 225 square centimeters and about 8 to 12 meters long. In the rolling mill, it is broken down into finished products such as bars, beams and sheet piles. In earlier mills, ingots were made from cast ingots (called "nodular iron"), but in modern mills they are made by continuous casting.

Production Procedure of Steel Bloom

The ingots, still hot sometimes, reach the tram plate mill and billet mill and are placed upright in a soaking pit under the floor by a special crane. Steel bloom are rectangular gas chambers about 5 meters deep, in which four to eight ingots are simultaneously heated to about 1,250°C (2,300°F). The soaking pit is highly computerized and can be used for scheduling, firing rate, heating time (lasting 8 to 18 hours) and rolling programs.

After heating, the conveyor carries the hot ingot to a two-high reversing mill, which passes, again and again, turning the roll and roll table over each time the ingot passes. Since each pass reduces the bloom by only about 50mm, 21 passes may be required, including several edges pass, and the bloom stands upright on its edge to obtain a slab bloom billet of 150mm*150mm.

HUAROoffers high-quality steel product, steel raw material and other raw material. We depend on Huaruo worldwide supply chain to

introduce and export our superior products.

Другие товары поставщика

	Iron Ore Concentrate	Description of Iron Ore Concentrate Iron ore concentrate is produced from the magnetite iron ore in the beneficiation process. When the iron ore is...
	Cold Rolled Coil	Description of Cold Rolled Coil Cold rolled coil, as known as CRS or CRC. Cold rolled steel coils are a farther product that uses hot rolled steel ...
	Iron Ore	How to Identify Natural Iron Ore Iron ores are rocks and minerals from which metallic iron can be economically extracted. The ores are usually ric...
	Pickled Coils	Description of Pickled Coils Pickling is a production procedure to remove the oxide scale on the cold rolled steel coil surface during steelmaking...
	Advantages and Disadvantages of Hot Rolled Steel and Cold Rolled Steel	Cold Rolled Steeland Hot Rolling Advantages and Disadvantages In general, the tensile strength, yield strength, plasticity, and toughness of hot...

Похожие товары

	SCC L8013Cr 2-7/8" EUE Tubing Coupling SSC	Продавец: Тяньцзинь Wenxin Energy Technology Co.,LTD	Introduction Copper plated coupling are short lengths of pipe used to connect 2 joints of casing...
	Special Clearance 1.9" N80 NUE Tubing Coupling	Продавец: Тяньцзинь Wenxin Energy Technology Co.,LTD	Introduction NUE Thread Couplings are short lengths of pipe used to connect 2 joints of tubing.T...
	DS55/HT55/HST55 4145h Crossover	Продавец: Тяньцзинь Wenxin Energy Technology Co.,LTD	Introduction Crossover is a tubing or casing for connecting two different sizes, threads and wei...
	X-over 3-7/8"CAS 2Cr13 Crossover	Продавец: Тяньцзинь Wenxin Energy Technology Co.,LTD	Introduction Crossover is a tubing or casing for connecting two different sizes, threads and wei...
	JFE BEAR Thread Type Super 13Cr Crossover	Продавец: Тяньцзинь Wenxin Energy Technology Co.,LTD	Introduction Crossover is a tubing or casing for connecting two different sizes, threads and wei...