Corner mesh machine
It is a new applied type building open angle-protecting mesh., it is made up of joint steel bar and pull-joint mesh, the pull-joint mesh form the 90В°angle through the joint steel bar, there are round hole on the pull-joint mesh which is parallel with the steel bar. The new applied type can protect and enforce the open angle, avoid the open angle falling off, distortion,crazing.The cost is low, the structure is simple, and can be operate shortcut, the construction is convince. It has the widely practicability. The angle-protecting mesh is shaped through extend of the hot galvanized plate and stainless steel plate. The two extended wings of the mesh can combine firmly with the compo, it used in the the building and form the smooth,straight,simple angle; and protect the angle from disrupting, hitting,and destroyed. The stock length is 2.4m--3m, or produce according to the customers' request.
Other supplier products
|
|
Annealing equipment series |
Introduction：
Serving by liquid ammonia, ammonia decomposition furnace gas generation device thermal decompose with the effect of catalyst to produ... |
|
|
straightening and cutting machine |
Our concrete-bar straightening cutting machine is adequate for straightening cutting coil rod or cold drawn steel bar |
|
|
straightening and cutting machine |
Our concrete-bar straightening cutting machine is adequate for straightening cutting coil rod or cold drawn steel bar |
|
|
Straightening-cutting machine |
concrete-bar straightening cutting machine：
Our concrete-bar straightening cutting machine is adequate for straightening cutting coil rod or cold d... |
|
|
Corner mesh machine |
It is a new applied type building open angle-protecting mesh., it is made up of joint steel bar and pull-joint mesh, the pull-joint mesh form the 9... |
All supplier products
Same products
