Dynamic Bending Tester for Automotive Wires
Main parameters: The length of the test sample is 200mm, and the clamping length of the test sample is 128mm. The minimum dynamic bending angle is 30 degrees, and the maximum is 135 degrees. The number of bending times is 300, and the counter is 4 - digit. The bending cycle is 3 seconds. The material is stainless steel. It is equipped with a 200W servo motor. The controller uses a combination of a touch screen and PLC (Programmable Logic Controller). The power supply specification is 220V, 50Hz. These parameters provide specific descriptions of the usage and performance of this testing machine.
![企业微信截图_.png]()
Other supplier products
|
|
Abrasive Wear Testing Machine |
Main Purposes
The wet - type rubber wheel abrasive wear testing machine is primarily employed to assess the wear - resistance of metal materials w... |
|
|
Flexometer / Bally Leather Flexing Tester |
TRANSLATE with x
English
Arabic
Hebrew
Polish
Bulgarian
Hindi
Portuguese
Catalan
Hmong Daw
Romanian
... |
|
|
GMA Ultra-filtration Membrane Porometers |
TRANSLATE with x
English
Arabic
Hebrew
Polish
Bulgarian
Hindi
Portuguese
Catalan
Hmong Daw
Romanian
... |
|
|
Air-cooled Xenon Lamp Aging Tester |
The air-cooled xenon lamp aging tester is a device that uses an air-cooled system to dissipate heat and a xenon lamp to simulate ultraviolet light,... |
|
|
Gloss Meter |
Industry Applications: In industries such as inks, paints, varnishes, coatings, and wood products, gloss meters are used to measure the surface glo... |
供应产品
Same products
