Pinion Gear

When we intend to change the machining process to PM,Website:http://www.dewin-powdermetallurgy.com, we need to consider 4 questions: 1.     The quantity is big enough to ensure the investment of mould is reasonable, because the machining maybe doesn’t need to make mould; 2.     Evaluate the structure and tolerance, to prove the feasibility, then offer necessary changes;3.     Evaluate the required physical properties, it should be in the limitation of PM process;4.     Calculate and see if the PM process is really cost-efficient than other technologies. Gennerally speaking, there are few parts which are totally meet all above 4 points, but anyhow, the successful decision of PM is the result of positive compromise and deeply technical conversation. The main classifications of gear:1.     Pinion gear2.     Ring gear3.     Duplicate gear4.     Sprocket5.     Pulley6.     Worm gear7.     Spline hub They are widely used in motor, enginee, gearbox, oil pump, water pump and other structure of transmission. Advantages of PM gear:Few waste of the material, formed directly by only one or two times of pressingHigh efficiency, stable quality levelLow material and production cost Weakness of PM gear in comparison with machining gear:Yield strength, breaking stength of the toothDensity 7.2 g/cm³Profile precision H6~H8Macrohardness 25-40 HRCMicrohardness 60 HRC Max The application of PM partsAutomobile:Enginee parts, crankshaft timing belt pulley, water pump pulley, oil pump pulley, driving and driven gear, driving and driven sprocket, cam, bearing cap, rocker arm, bushing, thrust plate, valve guide, inlet and exhaust valve seat.Transmission parts, gear hub and parts of various high and low speed synchronizer, clutch gear, cam and camshaft (*), sliding block, shift lever, axle sleeve, guide block, synchronous ring. Motorcycle:Driven gear and parts, sprocket, starter pawl, ratchet, star gear, duplicate gear, pinion gear, gear ring, variable gear, pushrod cam, shaft sleeve, sliding bearing, centring sleeve, driven disc, inlet and exhaust valve seat. Oil pump parts:Oil pum gear, gear hub, various rotors, inner rotor and outer rotor, gerotor, cam ring.   


在线询价

至: DEWIN GROUP LIMITED
Your E-mail:
消息正文:


Send to other suppliers

Other supplier products

供应产品

Same products

cold shrink tubing 卖方: Fast Industrial and Trading Limited
cold shrink tubing 卖方: Fast Industrial and Trading Limited
cold shrink tubing
cold shrink tubing 卖方: Fast Industrial and Trading Limited
DC 12/24V Saltwater Electric Outboard Motor, White Electric Trolling Motor, Boat Engine
DC 12/24V Saltwater Electric Outboard Motor, White Electric Trolling Motor, Boat Engine 卖方: Ningbo Gengjia Metal Products Company
火车闸瓦、机车闸瓦、合成闸瓦
火车闸瓦、机车闸瓦、合成闸瓦 卖方: 昆山艾力克斯铁路配件有限公司 火车闸瓦(合成闸瓦、复合闸瓦、高摩低摩闸瓦) 一、火车闸瓦概述 刹车片在铁路用语上称作闸瓦,闸瓦位于车轮的踏面上,当要煞车时,经由轫机的作用,让车轮前后的两片闸瓦将车轮夹紧,达到停车的目的。火车...