W0830 fish type three braid
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
construction equipment cable winch, engine winch |
engine winch/Cable Drum Winch Application: It's used for erecting pole, hoisting, stringing wire in power line operation. Powered winches are the c... |
|
cable wire stripper |
1.tungsten steel blade,hard and sharp. 2.Can cut the smooth degree of slope. 3.For cutting out the standard of thick wide angle,diameter of the cab... |
|
HZ-45 Hydraulic cable cutter |
Specifications Cutting range:DIA.45mm Cu/Alu cable and Amoured Cu/Alu cable Two stage hydraulic to reduce cutting cycle,autimatic release pressure ... |
|
BZ-65C/85C/105C battery Powered Cable wire Cutting tool |
Feature:Manual crimping tool: BZ-65C/85C/105C crimping range:dia 65mm.85mm,105mm BATTERY CABLE CUTTER FOR DIA 85MM Cu/Al CABLE AND ARMOURED CABLE 1... |
|
fish type W0850 with 7cm wire-rope |
1. It is easy to lead, can be used in narrow passage and limited space 2. A lot of the handle, the user can better control to use 3. Self expansion... |
供应产品
Same products