W0830 fish type three braid
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
|
cable wire stripper |
1.tungsten steel blade,hard and sharp. 2.Can cut the smooth degree of slope. 3.For cutting out the standard of thick wide angle,diameter of the cab... |
|
|
low price Cable pulling winch, new type Powered Winches,Cable Winch |
Uses: applicable to field construction traction hoisting machinery equipment and electric power, post and telecommunication line group made tower, ... |
|
|
Cable rollers linear DPHC03 |
Detailed Description Used in the cable changing the direction place protection cable not to wear. Features Divides into according to the material q... |
|
|
middle cable pulling |
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additi... |
|
|
Horizontal release frame type cable jacks |
Application Used to support wire reel when laying cable .Hold up the wire tray. Usage: for expanding the wire, the whole set of line on the six ... |
Все товары поставщика
Похожие товары
