L0750T Export standard duct rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
Winding machine, conveyor, trailer |
cable winch is composed of a roller wheel, gearbox, diesel or gasoline machine and a base frame, the mobile cutter grinding principle: cutter grind... |
|
|
BS-30 alkali-free glass fiber fish tape |
Flexible reinforce fiberglass core with polyethylene coating. professional electricians rely on brand! It is Light, Strong and Smooth with a steel ... |
|
|
Horizontal cable drum jack Service Drum Dispenser |
Application Used to support wire reel when laying cable .Hold up the wire tray. Usage: for expanding the wire, the whole set of line on the six ... |
|
|
BZ-45 Battery hydraulic cutter for Cu/Al cable armoured cable |
1.All tools can be controlled by one key-press the trigger to start working, half loosing the trigger means stop forcing pressure, loosing fully me... |
|
|
YQK-70 fast line pressing pliers |
Hydraulic crimping pliers：Monolithic crimping pliers, crimping pliers need to separate with the corresponding pump, general suitable for electric o... |
供应产品
Same products
