L0750T Export standard duct rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
BZ-85 hydraulic battery power Cable Cutter |
Cutting force:60KN Stroke: 86mm Cutting cycle:70 times Cutting range:dia 85mm (Cu/Al cable and armoured cable) Voltage: 18v Capacity: 3.0Ah Chargin... |
|
|
AS-15 Senior electrician fish tape |
Hand-held wire threading device is one kind of exporting products of our company, product features: reasonable design, safe and durable. appearance... |
|
|
Cable laying roller |
1.Application: Used for guiding cable to turn and set free. and used for setting power cable and communication cable in trenchers or on ground. 2.... |
|
|
Easy handle SETS OF STRIPPING TOOLS |
Application Suitable for stripping high-voltage cable insulation,Easily opens/separates the insulation on fiber optic cable. Cable stripper is use... |
|
|
T30 quick pulling 2016 best seller |
1.Made of steel wire rope 2.Density: 8（g/m） 3.Rod diameter 2（mm） 4.Temperature - 800 to 800 (℃) 5.Traction tension failure 800（kg） Operation: 1.B... |
All supplier products
Same products
