L06S20 sewer pipe inspection tools
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
Cable roller with ground plate |
Cable block is generally used in the ground and cable bridge frame protection of high voltage cable. The cable roller can protection 180 mm diamete... |
|
|
Hydraulic type cable dispenser |
Application: Suitable for cable tray support. Hydraulic lifting, casters at the bottom, easy to move. For line construction, extending wire shelvi... |
|
|
Heavy Duty 205mm Straight Line Bridge Roller |
Detailed Description Used in the cable changing the direction place protection cable not to wear. Features Divides into according to the material q... |
|
|
Steel Wire Rope 25-34mm Cable Pulling Mesh Grip |
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additi... |
|
|
BF-45 Powerful fish tape |
Features: 1) Strong non-conductive fiberglass rod construction. 2) Rustproof bull-nose pulling eye. 3) For longer conduit runs and underground duct... |
供应产品
Same products
