L06S20 sewer pipe inspection tools
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
|
electric tools multihole cable drum jacks |
Application: for general outdoor underground cable Actinobacillus operation, high-altitude stringing House switchboard construction wiring. Operati... |
|
|
L06S15 Cobra Duct Rodder |
1. It is easy to lead, can be used in narrow passage and limited space 2. A lot of the handle, the user can better control to use 3. Self expansion... |
|
|
T30 ELECTRICIANS PULLER RODS WIRES |
1.Made of steel wire rope 2.Density: 8（g/m） 3.Rod diameter 2（mm） 4.Temperature - 800 to 800 (℃) 5.Traction tension failure 800（kg） Operation: 1.B... |
|
|
BF-45 direct selling duct rodder |
Features: 1) Strong non-conductive fiberglass rod construction. 2) Rustproof bull-nose pulling eye. 3) For longer conduit runs and underground duct... |
|
|
BF-45 exportation fish tape |
Note: keep one hand holding the interior wall of Wire device while use it, and the other hand holding the handle of wire device, rotating clockwise... |
Все товары поставщика
Похожие товары
