T2 cable puller accessories
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
large multihole cable jacks |
Cable pulling and handling equipment: Hydraulic Cable Reel Stand 1. Used to support the cable drum. 2. Hydraulic lifting make it lift easily; 3. Ea... |
|
|
cable winch wholesale |
The use of ground grinding security technology (1) the ground should be put on the flat, accessibility, and fixed tightly, prevent the ground plane... |
|
|
2016 hot sale Cable laying roller |
1.Application: Used for guiding cable to turn and set free. and used for setting power cable and communication cable in trenchers or on ground. 2.... |
|
|
T50 Electricians Puller Rods Wires Draw Push Pulling |
1.Made of steel wire rope 2.Density: 8(g/m) 3.Rod diameter 2(mm) 4.Temperature - 800 to 800 (℃) 5.Traction tension failure 800(kg) Operation: 1.B... |
|
|
L06S10 wall Tracing Duct Rod |
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secon... |
供应产品
Same products