T2 cable puller accessories
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Другие товары поставщика
|
|
Electric power line construction grinder, cable winch |
Powered Winches,Cable Winch,ENGINE WINCH,Cable Drum Winch,Cable pulling winch Application: It is used for tower erection, stringing in electric pow... |
|
|
DP011-3 cable stand |
DP011-3: Rated Load-3T, apply for drum dia 700-2100mm, application of disc width-below 1500mm, shaft diameter-60mm, weight-75kg DP011-5: Rated Loa... |
|
|
push pull rod cable access kit cable puller |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
|
|
T2 cable puller accessories |
Operation: 1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into... |
|
|
BF-15 cash on delivery duct rodder |
Note: keep one hand holding the interior wall of Wire device while use it, and the other hand holding the handle of wire device, rotating clockwise... |
Все товары поставщика
Похожие товары