L06S50 Tracing Duct Rod
then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
FHT-300/400G split type hydraulic clamp crimping tool |
when using the surface pressure molding department not to rust, damage and dirt. Crimping pliers, if in the case of die residual metal debris still... |
|
|
CPC-100B Cable Cutting Head for telephone Cu/Alu cable |
Features: Split hydraulic cable cutter can work with hydraulic hand pump or electric hydraulic pump, it is suit for big size of tele cables or armo... |
|
|
BF-45 high quality of fish tape |
Features: 1) Strong non-conductive fiberglass rod construction. 2) Rustproof bull-nose pulling eye. 3) For longer conduit runs and underground duct... |
|
|
2016 Cable stripping tool |
1.Stripper tool. 2.Comfort grip, ergonomic handles. 3.Cable stripper fiber optic. 4.Has a crosswise stripping function . 5.The new handle has a bet... |
|
|
duct rodder scraper |
Fiberglass duct rodder features 1.Light weight,durable,resistance to acid,alkali,aging resistant,corrosion resistant. 2.High tensile strength and b... |
供应产品
Same products