L06S50 Tracing Duct Rod
then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
|
Electric tools Cable Drum Screw Jacks 3tons to 15 tons |
applicable to be as the support of large cable reel in laying cables in the city easy to move with the trundles in the bottom can be equipped with ... |
|
|
CYO-510B 50-400 square crimping pliers |
1 manual ratchet crimping pliers use and maintenance of the matters needing attention 2 don't charged line pressing, or in the vicinity of a charge... |
|
|
AS-15 cable wire device eco duct rodder |
Note: keep one hand holding the interior wall of Wire device while use it, and the other hand holding the handle of wire device, rotating clockwise... |
|
|
duct rodder Suppliers |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
|
|
Cable Running Rod |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
Все товары поставщика
Похожие товары