Mg Alloy Flux
Magnesium alloyfluxhas a low melting point and small heat capacity. When heated in the air, it gets oxidized fast, and it is easy to burn when overheated. When in a melting state without any flux, it can be burned violently. Therefore, the magnesium alloy must always be in flux or protective atmosphere during the casting process. The quality of molten casting depends greatly on the quality of the flux and the melt protection.
Other supplier products
|
|
Fluxes for Aluminum Alloy |
General Introduction:
SATA granular shaped fluxis a eutectic salt composed of mgcl2 anhydrous and potassium or sodium chloride. Which can removes a... |
|
|
Covering Flux-Csf1 |
C sf1is fused flux which does not contain any form of sodium salt and does not cause the alloy to be brittle, suitable for all kinds of aluminum an... |
|
|
Mg Alloy Flux |
Magnesium alloyfluxhas a low melting point and small heat capacity. When heated in the air, it gets oxidized fast, and it is easy to burn when over... |
|
|
Mg Remover Flux |
General Introduction:
Magnesium plays a very important part in producing the required physical properties of many , its presence in others is not r... |
|
|
Covering Flux-Csf2 |
C sf2 is an alkaline-based, sodium-free flux. It is a smoke-generating cover flux for all aluminum alloys, especially silicon-aluminum. It is used ... |
供应产品
Same products
