Resistance to flame propagation tester,ECE R118 Annex 10
Introduction
This equipment is designed and manufactured according to ECE R118 Annex 10. This model is intelligent, with PLC and touch screen intelligent control; program time is set freely, system automatically controls ignition time and automatically records test time, flameout time, etc.; test data system is automatically saved and accessibleat any time;
Standard
ECE R118 Annex 10
Features
1.1. Chambersize: 1200mm long x 600mm wide x 1300mm high; To ensure sufficient air supply for the test;
1.2. The test part and control part are integrated design, which is convenient for installation and commissioning
1.3large glass observation window, beautiful and easy to observe the combustion state of the sample;
1.4Ergonomic design, easy to touch the sample, burner pull rod is easy to operate
1.5. Stainless steel wire sample clamp;
Burner and gas control
2.1. Burner angle can be adjusted conveniently at 0 and 45 degrees;
2.2. The burner is imported from the United States, with cylinder length of 100 mm ± 10 mm and inner diameter of 9.5 mm ± 0.3 mm;
2.3. The burneritself can adjust the air intake;
2.4. Imported flowmeter and precision needle valve to precisely control gas flow.
2.5. Imported high-precision pressure regulating valve and pressure gauge 0 ~ 0.4MPa;
2.6. Accurately control the height of blue cone 50mm ± 2mm; total height 100mm;
Control system
3.1. 7 "touch screen +PLC to realize control / detection / calculation / data display
3.2. Electronic automatic ignition.
3.3. Automatic recording and storage of burning time
3.4 The automatic timer can record the test time and store it in the system, and the report can be inquired;
3.5.Tthe test time system automatically records and generates the test report;
3.6 test time and heating time can be set on the touch screen. Meet the requirements of various test standards;
3.7、Independent cablefire test procedure.
3.8、Exhaust fan is equipped at the top,when the test is finished,it willexhaust the gas generated during test.
Note: customerprepareexhaust pipe and gas.
Accessories
4.1. 304 stainless steel flame height gauge;
4.2. One set of stainless steelsample holder;
4.3. Accuracy 0.5mm, stainless steel ruler;
4.5 Manual;
4.6 Certificateof quality;
4.7. Plywood case;
Electrical
5.1、Power supply:220V，50/60Hz;
在线联系供应商
Other supplier products
 |
Syringe needle flow tester | The Syringe Needle Flow Tester is designed to evaluate the flow characteristics of syringes by measuring the volume of liquid discharged over a spe... |
 |
Battery combustion tester，Battery Cell Fire Tester，IEC 62281 | Product Description Battery combustion tester is a device that can be applied to the safety test of lithium-ion batteries, which can realize the s... |
 |
Bone Cement Four-Point Bending Fatigue Tester | Standard YY/T 1429 (China): Specifies four-point bending fatigue tests for acrylic resin bone cements under quasi-static and cyclic loading. ISO ... |
 |
Small Parts Tester | Test Procedure: Usage Methods and Interpretations Applicable standards: ASTM F963 EN 71-1 16 CFR Part 1501 ISO 8124-1 Product Advantages: Eff... |
 |
Textile Fiber Composition Analyzer | Standard ASTM D276(Standard Test Method for Identification of Fibers in Textiles) ISO 1833(Determination of Fiber Content in Textiles) AATCC 2... |
