Drop Former Stator Shaft
The stator is a partially biased circular column stick,Website:, inside which there is a material trough and two hot medium channels for heating and heat insulation. The material enters the material trough and is discharged by the metering bar. The two hot medium channels use heat conducting oil or hot water or steam, which prevents material in the trough from solidification. The stator can rotate ±10°to adjust the dropping angle , thus achieving high quality grain shape. The stator can also rotate ±90° to install high and low viscosity metering bars. The rotation of the stator is controlled by the joystick at the stator end.
Other supplier products
|
Steel Belt Drum System |
There are drums on the tight end and drive end for each,Website:, whose diameter is 1000mm. Both sides of the drum use material Q235, with orange a... |
|
Drop Former Rotating Shell |
The rotating shell is a very thin sleeve. There are many small sharp nozzle holes on its outside surface,Website:, which are arranged in certain fo... |
|
Drop Former Stator Shaft |
The stator is a partially biased circular column stick,Website:, inside which there is a material trough and two hot medium channels for heating an... |
|
Steel Belt |
Granulator for steel belt and the difference between non-exclusive steel beltSHANGHAI REBO GRANULATOR company limited based on the principle of res... |
|
Resin Pastillator |
Resin PastillatorProduct introduction:The liquid is fed by means of a jacket pump from the storage tank to the drop former by jacket piping. These ... |
All supplier products
Same products