BUE 3-Jaw Pull Back Draw Down Power Chuck for I.D.verticality and parallelism
(1). BUE I.D. pull back chuck apply for machining verticality and parallelism have the required workpieces, such chuck a wide range of clampings.
(2). When processing different workpieces, only need to change the soft jaws to use.
(3).Centrifugal force compensation.
(4). Less maintenance, lower wear, long-term stable accuracy, constant clamping force.
(5). Repeat positioning accuracy up to: 0.02mm.
(6). Chuck diameter range: 130-381 mm, 5 to 15 inch
(7). Material: Steel.
(8). Clamp and pull back the workpiece inner diameter, with a strong clamping force.
Other supplier products
|
|
LN/LT 2-Jaw / 3-Jaw Inner-Cylinder Hollow Vertical Pneumatic Power Chuck Fixture For Drilling And Milling |
(1).LN/ LT hollow pneumatic power chuck fixture has 4 inch, 6 inch, 8 inch, 10 size specifications and divided into 2-jaw type and 3-jaw type to ch... |
|
|
KL/KLT/KLH 2-Jaw / 3-Jaw / 4-Jaw Long Stroke Solid Hydraulic Power Chuck |
(1). KL / KLT /KLH solid hydraulic chuck with 4 inch, 5 inch, 6 inch, 8 inch, 10 inch, 12 inch size and divided into 2- jaw type, 3-jaw type, 4-jaw... |
|
|
KBL/KBLT 2-Jaw / 3-Jaw Ultra Long Stroke Hydraulic Power Chuck |
(1). KBL / KBLT hydraulic chuck with 6 inch, 8 inch, 10 inch, 12 inch,15 inch,18 inch size and divided into 2- jaw type, 3-jaw type, . (2). Clampin... |
|
|
K-Y/ K-A High-Speed Standard Solid Rotary Hydraulic/Pneumatic Cylinder For Short Material Processing |
(1). K-Y/ K-A high-speed solid rotary hydraulic / pnerumatic cylinder is the most commonly used rotary cylinder. (2). Light weight,high speed rotat... |
|
|
MDS/MDL 3-Jaw / 6-Jaw Diaphragm Clamping Power Chuck For Gear Processing |
(1). Diaphragm chuck is a fully sealed chuck, 3-jaw type, 6-jaw type to choose. (2). It is based on the outer diameter of the gear P.C.D for clampi... |
All supplier products
Same products
