ASTM D2061 Zipper Cycling Tester | Zipper Endurance Test Equipment Supplier
Get a quote：
Whats/App: +86 156 1874 6768
Web: standard-groups.com
Features
1. The counter adopts LCD display, 0~ 999.999 continuous adjustable;
2. Adjust zipper stroke according to different standard;
3. Automatic stop and alarm for 10S upon reaching the set number of times;
5. One set each of specially manufactured large and small zipper head fixtures, for the convenience to used zipper heads in different specification.
6. The positioning block ensures that the transverse pull clamp maintains tranversely tight at 10° at the beginning of clamping.
7.It has point adjustment function and fine tuning handwheel to facilitate the adjustion of installation position;
8.The zipper clamp is made of stainless steel
Technical Parameters
| Items | Parameters |
| Reciprocating speed | 30 double times/min |
| Reciprocating stoke | 75mm |
| Horizontal clamping device width | 25mm |
| Vertical clamping device width | 10mm |
| Two clamping device distance | 6.35mm |
| Friction head size | 20mm*20mm |
| Surface friction head | Dead weight:200g |
| Round-trip distance | Low load 120mm; High load 150mm |
Test Procedures
1. Roughly fix the zipper end (bottom stop) to point A (pull tab facing inwards);
2. Fix the pull tab to the pull tab clamp;
3. Fix the zipper front end (top stop) to points D and E;
4. Loosen point A, pull the zipper end upwards so that the fixing pin falls into the middle of the balance plate hole, then clamp point A (at this point, visually check that points D and E are on the same horizontal line);
5. Loosen the horizontal clamps B and C, allowing the fabric tape on both sides of the zipper to be placed into clamps B and C and clamped, with the clamp opening approximately 5mm from the tooth. At this point, all five fixing points are secured;
6. Adjust the zipper tester to its upper limit, loosen the pull tab clamp, and visually check if the zipper remains straight. If not, readjust until all clamping is complete;
7. For zippers of different specifications, apply load to their horizontal and vertical directions according to the specified requirements.
Send product request
Other supplier products
 |
Acid and Alkali Protective Clothing Tester Manufacturer Direct Sale Factory Price | Get a quote： Whats/App: +86 156 1874 6768 Web: standard-groups.com Application You use this tester to assess splash and spray liquid tightness ... |
 |
Affordable Sand - Falling Testing Machine for Motorcycle Helmets | Whats/App: +86 156 1874 6768 Web: standard-groups.com The sand abrasion tester is a specialized testing device used to evaluate the abrasion resi... |
 |
ASTM D2843 smoke density tester | Whats/App: +86 156 1874 6768 Web: standard-groups.com Application You can use the F313 Plastic Smoke Density Tester in the following areas: Pla... |
 |
Glove Cut Resistance Tester | Whats/App: +86 156 1874 6768 Web: standard-groups.com Product Introduction: The machine is used to test the cutting resistance of gloves. Under ... |
 |
Big 45°Method Suture Flame Contact Times Tester | Whats/App: +86 156 1874 6768 Web: standard-groups.com This instrument is used for testing flame exposure times of flame retardant protective clot... |
