UV preconditioning testing chamber for pv module
Standard:According to IEC61215, IEC61646 standard requirement
Purpose:to precondition the module with ultra-violet (UV) radiation before the thermal cycle/humidity freeze tests to identify those materials and adhesive bonds that are susceptible to UV degradation
Technical specifications:
1、Use material:can completely obstruct ultraviolet rays,tightness,good thermal insulation’s high quality materials
2、Machine UV total irradiation area:more than 2000mm×2000mm,meanwhile satisfy 2 pcs module (2m×1m)
3、Light source life :system use Xenon lamp single lamp life is 1000 hours , delivery offer one set of spare part, use the life at above 2000 hours
4、Single lamp UVA and UVA relative energy rate:UVB approx occupy total energy 3%~10%
5、Irradiation strength:wavelength 280nm~385nm’s irradiation strength can reach about 100W/m²,280nm~320nm ≦10%,promise the test cycle reduce as far as possible
6、Irradiance uniformity:be better than ±15%
7、Real-time monitor and show UVA and UVB strength
8、UVA (320nm~385nm), UVB(280~320nm) Each one of the fiber optic probes
9、Module surface temperature:60℃±5℃
10、Temperature resolution:0.1℃
11、Ozone: almost no ozone is produced
12、Light ways :upper light, module test plane vertical light source
13、Touch screen operate and real-time monitor , when reached the set value will automatic cut off the light source
14、Real-time figure show module surface temperature, measurement accurate±0.1℃
Send product request
Other supplier products
UV preconditioning testing chamber for pv module | Standard:According to IEC61215, IEC61646 standard requirement Purpose:to precondition the module with ultra-violet (UV) radiation before the therm... | |
Thermal cycle/humidity freeze environment chamber | Standard:According to IEC61215,UL1703 standard requirement Purpose: To determine the ability of the module to withstand thermal mismatch, fatigue ... | |
Solar panel Damp heat testing chamber with IEC 61215-2:2016 standard | Standard:According to IEC61215,UL1703 standard requirement Purpose:To determine the ability of the module to withstand the effects of long -term p... | |
Hail Impact Tester for pv module | Standard:According to IEC61215,IEC61646,UL1703 standard requirement Purpose:to verify that the module is capable of withstanding the impact of hai... | |
Mechanical Load Tester for pv module | Purpose: This test is to determine the ability of the module to withstand wind , snow , static or ice loads Technical specifications: 1、The mach... |
Same products
Disposable Dental Needles | Seller: Shanghai Kohope Medical Devices Co., Ltd. | The dental needles manufacturing, also named disposable dental needles and tooth needles, are ass... | |
ULTRASONIC STEEL PIPE TESTING EQUIPMENT | Seller: Hebei tianxianghao metallurgical equipment manufacturing co.,ltd | Ultrasonic pipe testingwith ultrasonic pipe inspection equipmentrefers to a non-destructive testi... | |
STEEL PIPE STORAGE RACK | Seller: Hebei tianxianghao metallurgical equipment manufacturing co.,ltd | Metal Pipe Storage Racks This ms pipe storage rackmachine serves as a storage system for inspect... | |
STEEL PIPE ROTATING ROLLER TABLE | Seller: Hebei tianxianghao metallurgical equipment manufacturing co.,ltd | This equipment is suitable for the detection and repair welding process in the production of spir... | |
STEEL PIPE END EXPANDING MACHINE | Seller: Hebei tianxianghao metallurgical equipment manufacturing co.,ltd | Pipe expanding machineis a professional equipment for expanding and rounding the end of spiral su... |