G612 national standard shoe wear testing machine
Product Introduction:
The whole shoe wear testing machine is used to test the wear resistance of soles and sole pieces. The principle is to press the rotating grinding head vertically above the sample, and carry out rotary wear test on the test sample at a certain load weight and a speed of 191r/min. After the test is completed, the wear length of the sample is measured to evaluate whether the sample is qualified.
Reference standard:
GB/T 3903.2-2017, QB/T4329-2012 and other standards
Technical specifications:
Performance: Accurate weighing, stability, good repeatability, the use of environmental requirements: at a specific temperature （23±2℃）， measuring the weight of the material and water
Speed: （191±5）r/min（adjustable）
Load: 500g（5g-500g optional）
Test time: 20 minutes （adjustable）
Grinding wheel: 20±0.1 diameter 4±0.1mm thick, T12 steel grinding wheel, with 72 teeth, tooth Angle 90°±5°, tip width 0.2±0.05mm, tip roughness Ra=3.2um, hardness HRC³55, coaxiality 0.03mm
Balance range: 5000g, accuracy: 0.5g
Volume: 560×510×830mm
Weight: 70kg
Power supply: AC220V,10A
Send product request
Other supplier products
 |
Mechanical load testing machine for photovoltaic modules | Standard IEC 61215: Terrestrial Photovoltaic (PV) Modules – Design Qualification and Type Approval IEC 61646: Thin-Film Terrestrial Photo... |
 |
20L Spherical Explosion Tester/ 20 Liter Explosion Test Chamber / Spherical Vessel Explosion Tester | Product Description: 20L Spherical Explosion Tester is characterized by accurate test data and ease of use. Its through the compressed air will be... |
 |
Vehicle Cabin Air Filter Tester | Applicable standards: DIN 71460-1 Road vehicles - Air filters for passenger compartments of motor vehicles - Part 1: particulate matter filtration... |
 |
Helmets Acceleration Impact & Penetration Tester | Standard GB/T 2812: Safety Helmets (China National Standard) Equivalent Compliance: ISO 6220-1 (Industrial Safety Helmets – Impact Absorp... |
 |
Creep testing machine with full incision/ Full-Notch Creep Tester / FNCT Creep Testing Machine | Standard ISO 16770: Exclusively designed for full-notch creep testing (FNCT) of thermoplastics under sustained stress. ASTM D2990: Configurable... |
Same products
 |
Thrust Bearing Rolling Friction and Wear Testing Machine | Seller: Standard International Group (HK) Limited | Applicable Standards: ASTM D3702 ASTM G99 ASTM G77 ISO 18535 Product Advantages: Simulates ... |
 |
Falling Sand Abrasion Test machine | Seller: Standard International Group (HK) Limited | The sand abrasion tester is a specialized testing device used to evaluate the abrasion resistance... |
 |
Conveyor Belt Drum Friction Testing Machine | Seller: Standard International Group (HK) Limited | Main Purposes of Conveyor Belt Drum Friction Testing Machine The conveyor belt drum friction tes... |
 |
Dry Sand Rubber Wheel Wear Tester | Seller: Standard International Group (HK) Limited | The dry sand rubber wheel abrasion tester is mainly used to test the abrasion resistance of mater... |
 |
Sliding Bearing Fatigue Testing Machine | Seller: Standard International Group (HK) Limited | The sliding bearing fatigue testing machine is an important testing device, mainly used to evalua... |
