Band saw cutter using fly cutter type
Cross cutter with bang saw or disc saw
The cross cutter saw will receive a continuous processed panel from the laminator system. The saw consists of the following major items:
Main internal cutting frame/harp with cross travel driven by a 3 phase motor through a high quality linear guide way.
Outside main carriage with panel clamping during cutting.
Mechanical tensioning of band saw blade
Floor frame with mechanical driven return
Main control console with PLC and electrical controls
Variable speed cross cut via variable frequency drive controls
PLC and computer software batching system control.
The band saw should be located in an enclosure to minimize the affects of noise on personal nearby. This enclosure is customer supplied and manufactured from production panels from the machine
Saw operation is as follow:
On activation of a cut cycle, rubber coated clamp on the panel and travel with it while the band saw performs the cutting cycle. The band saw will then travel across the panel and cut entirely through both steel skin and the core.
The band saw could controls the speed at the joint edges of the panel, slowing the cross cut travel as it cuts through the joint areas
Once cutting is complete, the band saw will revolving after cutting for next cutting. The cutting saw can revolve, so cutting in two directions is realizable. After cutting it release the clamps and return to the home position, ready for the next cutting cycle
The main carriage will then return to the home position for the next cutting cycle
The cutting cycle can be initiated manually or by automatic length-cutting in conjunction with the central line system
This machinery is designed to cut panel during production of up to 1250 mm wide and up to 250mm thick.
Cutting machine can move 2500mm longitudinally along product line;
Band saw of the cutting machine can move transversely 1900mm, Cutting machine moves longitudinally and transversely along the slide way.
Cut length capability
Maximum cut length is only subject to transportation limitations
The dust hoods come with two openings provided on the cross-cut saw assembly. There is one catcher hood provided on the end of cross-cut saw. The dust collection system (used to pull the dust away and dispose of it) will be the responsibility of the customer.
Conveyor from band saw to cooling system machine
The band-saw out-feed conveyor is a powered roller conveyor approximately 15 meter long and approximately 1320 mm wide.
Другие товары поставщика
|
|
Ceiling panels roll forming machine with hydraulic profile cutter |
Ceiling panels roll forming machine working flow Decoiling steel sheet →covering film→pre-cutter→Guiding system→Roll forming&ra... |
|
|
PUR, PIR (Polyurethane)， Rock wool,mineral wool,glass wool Sandwich Panel Product Line |
PUR, PIR (Polyurethane)，Rock wool Sandwich Panel Product Line could automatically make PUR,PIR,rock wool,mineral wool,glasswool sandwich panel for ... |
|
|
Automatic and hydraulic uncoiler with coil car |
Uncoilers or Decoiler It is Automatic and hydraulic, can be used to uncoil steel coil which is maximal 1300mm’s wide, no more than 12 ton&rsq... |
|
|
Roof roll forming machine with hydraulic profile cutter |
Roof roll forming machine could make roof profile steel sheet. It could be used independently or used in whole sandwich panel line. The main compos... |
|
|
EPS and rockwool /mineral wool /glasswool sandwich panel product line |
EPS and rockwool /mineral wool /glasswool sandwich panel line could make rock wool,mineral wool,glasswool，EPS sandwich panel for wall and roof.The ... |
Все товары поставщика
Похожие товары
