American European bending test meter
Test Purpose：
To determine if metal wires in children's products bend or break under stress, creating sharp edges or points that pose choking or injury hazards.
Compliance Standards：
16 CFR CPS USA: Child Product Safety Certification
ASTM F963: Standard Consumer Safety Specification for Toy Products
EN 71: European Toy Safety Directive
Product Advantages:
Ensures Child Safety: Directly tests for potential hazards from metal wires, significantly reducing the risk of cuts, punctures, or ingestion of broken pieces.
Dual Market Compliance: Designed to perform tests required by both US (ASTM, 16 CFR) and European (EN 71) standards, simplifying testing for manufacturers targeting both markets.
Objective and Quantifiable Results: Provides measurable outcomes (deformation percentage, breakage force) and a pass/fail assessment for sharp edges based on standardized methods.
Supports Design and Quality Control: Valuable for validating material choices, evaluating product design, and performing quality checks during manufacturing.
Reduces Risk of Recalls: Helps prevent costly and damaging product recalls by ensuring compliance with safety regulations before products are shipped.
Acceptance Criteria：
No permanent deformation exceeding 15% of original length
No sharp edges exceeding 0.5mm radius
Maximum allowable breakage force ≥ 2N
Parameter：
| Test Parameter | Specification |
|---|---|
| Deformation Test | Apply 3N axial force for 5 minutes |
| Bend Test | Flex the wire at 90° angle with 5mm radius mandrel |
| Edge Evaluation | Check for sharp edges using ISO 4671-1:2017 gauge |
Отправить запрос, связаться с поставщиком
Другие товары поставщика
 |
Impact strength tester for car seat launching headrest | Applicable standards: GB 11550-2009"Performance requirements and test methods for car seat headrest" : Appendix B of this standard specifies the r... |
 |
Goggles Puncture Resistance meter | Applicable standards: GB 811-2010 ECE R22.05 EN1077 Purpose It is to make a certain weight of sharp objects fall from the height specified in ... |
 |
Minimum Ignition Energy (MIE) – Dust Cloud Tester | Description： Dust Cloud Minimum Ignition Energy Tester disperses a certain mass of dust specimen to be tested into the Hartmann tube device thro... |
 |
Sliding Bearing Fatigue meter | Standards ASTM D2596 / ASTM D2783 / IP 239 EP, DIN 51350 / 1-5. ISO / CD 11008. VW 1444. VW 1454 Material Research and Development During the re... |
 |
Solid electrolyte analysis device | Standard ISO 9001:2015(Quality Management System) ASTM E1970-21(Standard Guide for Electrochemical Impedance Spectroscopy) IEC 62660-2(Secondary... |
Похожие товары
 |
Plastic Smoke Density Tester F313 | Продавец: Standard International Group (HK) Limited | The F313 Plastic Smoke Density Tester is a precision instrument designed to measure the specific ... |
 |
Xenon Test Chamber | Продавец: Standard International Group (HK) Limited | Features and Benefits 1.The use of xenon arc lamp as a light source, can simulate the full sunli... |
 |
Single Cable Vertical Flame Tester | Продавец: Qinsun Instruments Co., LTD | Introduction Single Cable Vertical Flame Tester is used for the vertical flame propagation of a ... |
 |
Safety Helmet Flammability Tester | Продавец: Qinsun Instruments Co., LTD | Product Introduction: Safety hat flame retardant performance tester for safety hat flame retarda... |
 |
Furniture flammability tester | Продавец: Qinsun Instruments Co., LTD | Product details Furniture flammability tester is mainly used to test the combustion performance ... |
