Main functions and features

Gas sensors with high reliability

Modular sensor which is easy for change, maintenance and calibration.

Fast response, zero drift, high precision, and low power consumption

Controlled by microprocessor and it has the rapid response , high reliability and low failure rate.

Sound and light alarm at the scene

Cooperate with smart gateway, and installing APP can realize remote control and alarm.

linkage output with gas shut-off valve

Installation and Wiring Instruction

(1)The detector installation position should be specifically analyzed and determined based on actual situation of used gas and the location of the used fuel gas appliances. But it should follow the following principles:

Detector and fuel’s use instruments shall be located in the same room.

Please install the detector on the wall within horizontal distance of 1.5 meters from the fuel gas appliance.

Detection of liquid gas: installed in the ground 0. 3 m or so (because the proportion of liquefied petroleum gas is heavier than air).

Detection of gas: installed in the ceiling 0. 3 m or so (because the proportion of natural gas lighter than air).

If the rooms have spacer, detector and potential gas source should be in the same side of the spacer.

In a room with a sloping ceiling, the detector should be located at higher side of the room.

Detectors should be located in a zone close to breathing area of residents.

(2) Places where detector can not be placed.

Do not place the detector in the following places:

Directly affected by exhaust gas, steam and oil-smoke produced by the combustion apparatus.

The cupboard or beneath it.

Wet or humid place.

The temperature of places or outdoor is below 0 degree or over 55 degree.

Detector and gas equipment are isolated.

Near the doors and Windows or any place that may be affected by air, such as fan or porosity.

Dirt or dust can accumulatively block detector and prevent it from working.

Vulnerable to collide, damage or casually moved

(3) In which room Detector is installed?

Ideally, it is suggested that a detector is installed in every room with a fuel utensils. But if there are more than a burner and detector

number is limited, when determining the position, the following needs to be considered:

If the bedroom has a burner, the bedroom need to install a detector inside;

If a room has a burner with a chimney or ordinary flue type, you need to install a detector in the room

If in a room often used such as living room has electric appliances, you need to install a detector in the room

In a bedroom and a living room, the detector needs to stay away from cooking utensils and sleeping place as much as possible.

Attention!

Linkage output connector of gas detector has positive and negative polarity; if matched with Poer standard

solenoid shut-off valve, just need to joint the two butts. When using a third-party solenoid shut-off valve,

please confirm the following issue:

Solenoid shut-off valve must be with rated voltage DC9-12V, pulse driving current 1.0A-1.8A, pulse time >1s;

Pay attention to the correct polarity of linkage output connector.

Product specification

Model No.	PSG10
Sensor type	Semiconductor SnO2
Gas detected	Natural Gas or LPG (Butane , Propane)
Main power supply	230 V AC (-15%+10%) 50/60 Hz
Operational Environment	Temperature of -10°C~40°C humidity≤95%RH, no condensation
Storage temperature	-20°C ~ 50°C .
Pressure limit	86kPa ~ 106kPa
Power consumption	3 VA
Starting time	2 min. 30 sec.
Response time	≤30s automatic recovery
Sample mode	Natural spread
Alarming range	2% - 20% LEL.
Alarm triggering point	9% LEL (Lower Explosive Limit)
Type of alarm	Acoustic and light alarm
Alarm volume	≥70dB
RF transmission	433M/868M visual range is 100m
LED indicators	Power supply ON: green LED blink quickly Prepare heating: green LED keep light for 2m Alarm: green LED blink slowly, red LED stay on Paring success: green LED blink quickly Paring failed: red LED blink quickly RF communication good with gateway:green LED blink slowly RF communication bed with gateway:green LED blink slowly, red LED blink quickly Audible alarm: Buzzer min. 85 dB at 1 m
Lifetime of the detector	5years
Degree of protection	IP42
Housing material	ABS, UL 94V0
Operation place	indoor
Weight	About 270g
Dimension	Lx W xH, mm: 111 x 71 X 43 (with back plate)
Optional device	Gas solenoid cuts off valve

Heating energy is essential in the cold winter. Especially in cold countries and regions. Heating in winter is a big deal.

While enjoying the warmth. POERthermostatCompany is also thinking about whether we can effectively save heating energy through precise control of heating while maintaining and improving comfort.

To this end, we start the POER smart heating controlssystem. Committed to promoting more households to upgrade heating control and contributing to our common home.

If you want to know more types of smart gas detector, please visit our website.

Other supplier products

	POER Gateway PTG10	POER Wireless Smart Gateway Smart home control center for low voltage radiant floor heating Full Wireless Connection Strong Signal Touch button...
	Wifi Thermostat	Poersmart provides the programmable wifi central heating thermostat set. We have wifi water heater thermostats and wifi electric underfloor heating...
	POER Wireless thermostat receiver PTR10	Connect to thermostat PTC10 and gateway PTG10 Strong signal Two relays 433MHz and 868MHz optional Connect to gas boiler PTR10 has two sets of vol...
	POER Wireless Smart Gateway	Smart home control center for low voltage radiant floor heating Full Wireless Connection Strong Signal Touch button The gateway PTG10 serves as a b...
	Valve	DN15, DN20 Connection size: M30*1.5mm Thermal actuator valve Mainfold POER is located in Hangzhou China.POER has become one of the most professi...

All supplier products

Same products

	Nisin Supplier	Seller: Hebei Shengxue Dacheng Pharmaceutical Co., Ltd.	Solubility: Nisin's solubility varies with pH. For example: In water (pH = 7), its solubility is ...
	Syria-cryogenic cell storage-liquid nitrogen trolley	Seller: Henan Tianzhidao Biological Technology Co., Ltd	In the laboratory, liquid nitrogen is often used to preserve samples or cool equipment. However, ...
	Switzerland-cryogenic sample storage-liquid nitrogen dewar trolley	Seller: Henan Tianchi Instrument & Equipment Co., Ltd.	In the laboratory, liquid nitrogen is often used to preserve samples or cool equipment. However, ...
	Italy-liquid nitrogen tank for cell storage price-dewar trolley	Seller: Henan Tianzhidao Biological Technology Co., Ltd.	In the laboratory, liquid nitrogen is often used to preserve samples or cool equipment. However, ...
	Medical Mask Differential Pressure Tester	Seller: Qinsun Instruments Co., Ltd	Standards: EN 149, EN 14683, ASTM F2100, MIL-M-36954C, GB 19083, GB 2626, YY/T 0969-2013 ...