Vibration and Abrasion Resistance Tester for Automotive Wire-to-Wire
In terms of main parameters: The vibration frequency of the vibrating table is 10Hz, the amplitude is 6.35±0.25mm, and the vibration direction is horizontal vibration. The two support points for fixing the wires are located on the vibrating table, with a width of 280mm. The moving wires are located below the vibrating table. One support point is on the fixed table, and the other support point passes through a guide shaft with a diameter more than 14 times that of the sample. The distance between the vibrating table and the fixed table is 45mm. The friction support point is at the mid - point (10%) of the sample. One weight each of 10N, 12.5N, 15N and 20N is provided. When the wires are worn through and conduct electricity, the machine will automatically stop. The number of abrasion cycles can be set between 1 and 9999. These parameters define the specific conditions and operating specifications for the tests carried out by this tester.
Other supplier products
|
|
limiting oxygen index apparatus |
The Oxygen Index is, perhaps, the most economical and precise quality control test of combustible materials. Its ease of use together with high lev... |
|
|
Martindale Abrasion Tester |
Martindale Abrasion And Pilling Tester
Martindale Abrasion & Pilling Tester. To determine the abrasion and pilling resistance of all kinds of ... |
|
|
Ozone aging chamber |
Brief IntroductionThe textile ozen aging color fastness tester is mainly used for testing color fastness properties of fabrics exposed to ozone env... |
|
|
Sponge foam collapsible hardness tester |
Purpose:
This machine is used to measure the indentation hardness of porous elastic materials. The polyurethane foam sample can be tested accordin... |
|
|
Sublimation Fastness Tester |
Sublimation Fastness Testeris suitable for color fastness to hot pressing and dry heat test method test device fastness test method of resistance t... |
All supplier products
Same products
