Dynamic Bending Tester for Automotive Wires
Main parameters: The length of the test sample is 200mm, and the clamping length of the test sample is 128mm. The minimum dynamic bending angle is 30 degrees, and the maximum is 135 degrees. The number of bending times is 300, and the counter is 4 - digit. The bending cycle is 3 seconds. The material is stainless steel. It is equipped with a 200W servo motor. The controller uses a combination of a touch screen and PLC (Programmable Logic Controller). The power supply specification is 220V, 50Hz. These parameters provide specific descriptions of the usage and performance of this testing machine.
![企业微信截图_.png]()
Other supplier products
|
|
Precision Fiber Microtome |
Precision Fiber Microtome
Testing Standards:
ASTM D2130, BS 2043, DIN 53811, ISO 137, IWSTM 24, IWTO 8-6
Applications:
Precision Fiber Micr... |
|
|
Fabric Downproof Tester(Rolling Box) |
Fabric anti-drilling velvet testerMainly used in the production of down products and fabric of the anti-drilling velvet test, used to assess a vari... |
|
|
Car seat static strength tester |
Applicable standards:
GB 11550-2009 "Car seat headrest strength requirements and test methods" : This standard specifies the static streng... |
|
|
Wire bending tester |
Product Introduction:
Wire bending tester meets JIS-C-3005 test standard. The sample is inserted through the specified round hole according to thi... |
|
|
Automotive wire harness load integrated test bench |
Scope of application:
Meet ISO 8092.1 ——。4 series standards and QC/T417.1 —— 417.5-2001 automotive wiring harness connecto... |
All supplier products
Same products
