DT-JII Medium High Pressure Dual-stage Injection Molding Machine
Introduction
TEDERIC D-JII medium-to-high pressure dual-stage injection molding machine, developed by TEDERICCompany, combines extrusion and injection technology to form a dual-stage injection structure, injection pressure Max up to 130Mpa. It is based on D-JI, for expanding the application field of dual-stage machines. The plasticizing part adopts the extrusion technology, which has the advantages of balanced plasticizing and high efficiency; while the injection unit adopts the plunger reciprocating structure, to the advantages of precision, large injection volume, high efficiency and energy-saving, not only mainly used in the production of large thick-walled pipe fittings but also extend to more application like logistic and environmental area. The clamping force can be from 5000KN to 40000KN, and injection size from 6000cm3 to 430,000cm3. D-JII high pressure injection machineis a recommended machine for producing utility tunnels( inspection wells), pallet and dustbin.
Feature：
Extra large injection volume : injection pressure up to 130Mpa
High-efficiency – extrusion screw applied in plasticizing: Plasticizing efficiency is at least 30% higher than injection molding machines of the same injection volume
Energy saving : large size combined with small clamping unit, reducing energy consumption and costs
Send product request
Other supplier products
 |
DH-JII Two-platen Medium to High Pressure Dual-stage Injection Molding Machine | Introduction DH-JII all hydraulic injection molding machine series is of two-platen clamping unit, equipped with injection unit of large injection ... |
 |
DH-JII Two-platen Medium to High Pressure Dual-stage Injection Molding Machine | Introduction DH-JII all hydraulic injection molding machine series is of two-platen clamping unit, equipped with injection unit of large injection ... |
 |
DH-i Two-platen Injection Molding Machine | Introduction DH full hydraulic series injection molding machine is of two-platen, dual cylinder injection unit and clamping force from 480 – ... |
 |
DH-JII Two-platen Medium to High Pressure Dual-stage Injection Molding Machine | Introduction DH-JII all hydraulic injection molding machine series is of two-platen clamping unit, equipped with injection unit of large injection ... |
 |
DT-JI Lower Pressure Special Injection Molding Machine | Introduction TEDERIC D-JI low pressure injection molding machinedeveloped by Tederic Company combines extrusion and injection technology to form a ... |
