Airbag Sensor
The airbag sensor is the input device of control signal in the SRS system. When the vehicle happens to collides, the airbag sensor detects the intensity signal of the vehicle collision, and inputs the signal into the airbag computer. The airbag computer determines whether to detonate the inflatable element to inflate the airbag according to the signal of the airbag crash sensor.
How To Test airbag front sensor?
1) Symptoms of airbag system failure are difficult to diagnose, so diagnostic codes are the most important source of information for troubleshooting. Always check the diagnostic codes before disconnecting the battery.
2) Disconnect the ignition switch during inspection. If the vehicle allows to remove the negative electrode of the battery, it is better to disconnect the power supply. It should be started after removing the negative electrode for 90s or longer. Because the airbag system is equipped with a backup power supply, the airbag may still deploy within 90 seconds after removing the negative terminal of the battery.
3) Even if only a minor collision occurs and the airbags are not deployed, the front airbag pressure sensor and steering wheel cushion should be checked.
4) Do not expose the front airbag impact sensor, center airbag sensor assembly and steering wheel pad directly to hot air and flames.
5) When testing the circuit, a high-impedance multimeter should be used for measurement.
6) The parts of the airbag are attached with instruction labels, and the listed precautions should be strictly followed during operation.
7) After pulling out the airbag wiring plug, use a small copper wire to short the airbag connector.
8) Do not measure the resistance of the detonator tube of the airbag inflation element, so as not to cause the airbag system to explode by mistake. The method of decomposing the inspection parts should be adopted first, and then searching step by step.
9) The airbag system is a very sensitive device. A little carelessness during inspection may detonate the airbag and cause unnecessary losses.
10)The wire harness and connector of the airbag system are generally covered with a special color sleeve, which is different from other system wire harnesses. Do not damage these bushings during inspection.
As a professional auto spare parts supplier, we provide car ignition components, car ignition coil, etc. For impact sensor price or more information, please feel free to contact us!
Other supplier products
|
|
Camshaft Position Sensor Application |
The cam valve sensorcollects the position signal of the valve camshaft and inputs it to the ECU, so that the ECU can identify the compression top d... |
|
|
Windshield Wiper System |
The custom windshield wiper systemis not only as simple as wiping the water off the windshield, but also wipes the rainwater on the glass surface i... |
|
|
Windshield Wiper Blades |
Because of legal requirements, almost everywhere cars must be equipped with windshield wiper cutter. The windshield wiper cutter also has the chara... |
|
|
Car Air Filter |
The car air filter commonly used in passenger fuel vehicle engines mainly have paper air filter and polyurethane air filter. Paper air filters are... |
|
|
Windshield Wiper Switches |
The windshield wiper switchesis usually located on the right side of the steering wheel of the vehicle. It is a joystick-type switch. Just move the... |
All supplier products
Same products
