L-Type Finned Tubes
L type fin tubeare easy to manufacture and cheap, and are used in large numbers in petrochemical air coolers. However, since the aluminum fins are fastened to the surface of the steel tube by the initial stress of winding, the operating temperature is low, generally 120-160℃, and the maximum operating temperature of L-type finned tubes is 150℃ as stipulated in the national standard GB/T 15386-94 for air coolers. When the tube wall temperature exceeds 70℃, the fin tension is greatly reduced, the fins start to loosen, the contact thermal resistance increases, and the performance is not good. Therefore, L type winding tube is suitable for the situation of smooth working conditions and no sudden change in temperature, and should not be used for the situation of great vibration. It is poorly resistant to atmospheric corrosion and has a very short service life in wet air cooling.
Introduction of L-Type Finned Tubes
L fin tubeare one of specific types of finned tubes that feature a unique L-shaped fin design. The fins are attached to the outer surface of the tube, forming a series of continuous L-shaped profiles along the length of the tube.
The L-Type finned tubes find application in various industries, including power generation, petrochemical, and HVAC systems. They are commonly used in heat exchangers, air coolers, and condensers, where efficient heat transfer is essential.
The specific design and dimensions of L-Type finned tubes can vary based on the requirements of the application. Factors such as the fluid characteristics, operating temperature, and pressure conditions influence the selection of materials, fin geometry, and fin spacing to optimize heat transfer performance.
Overall, L-Type finned tubes provide an effective solution for maximizing heat transfer efficiency in various thermal management applications. Their unique fin design enhances surface area and heat exchange capabilities, contributing to improved system performance and energy efficiency.
Send product request
Other supplier products
 |
Evaporative Condenser | Evap condenser is a type of heat exchanger used to transfer heat from process fluids to the atmosphere. Unlike a direct air-cooled condenser, an ev... |
 |
SPUTTERING TARGET BONDING | Sputtering target bondingis a process that involves attaching a sputtering target to a backing plate or a substrate holder. The bonding process is ... |
 |
Molybdenum Sheet | Molybdenum sheetis a thin, flat piece of metal made from molybdenum. It is known for its high melting point, resistance to corrosion and wear under... |
 |
Molybdenum Crucible | Molybdenum crucibleis a container made from molybdenum metal used for high-temperature applications in industries such as aerospace, energy, and el... |
 |
Molybdenum Boat | Molybdenum boats are small, boat-shaped containers made of pure molybdenum or molybdenum alloys, usually used for high-temperature applications suc... |
Same products
 |
Low Temperature Cooling Heating System | Seller: Beijing Linggong Technology Co., Ltd. | Low Temperature Cooling Heating System Thermal Management Systems For Vehicle/Battery Testing. ... |
 |
Yoyik offer cooler GLC2-2.6 for steam turbine | Seller: DONGFANG YOYIK (DEYANG) ENGNIEERING CO; LTD | ""Yoyik offer cooler GLC2-2.6 for steam turbine YOYIK is a hi-tech company specializing in the pr... |
 |
Recirculated Air Heating and Cooling Unit | Seller: Fujian Air Technology Systems Co., Ltd | When hot/cold water or stream passes the Recirculated Air Heating and Cooling Unit, the efficient... |
 |
Water Chiller Manufacturers Near Me | Seller: Shanghai Kendall Refrigeration Equipment Co., Ltd | Headquartered in Shanghai, China, Kendall stands as a pioneer and leader in the refrigerati... |
 |
Cold Room Solutions | Seller: Shanghai Kendall Refrigeration Equipment Co., Ltd | At , we bring over 20 years of expertise in refrigeration design, construction, installatio... |
