Rack End
As one of the most famous rack end manufacturers and suppliers in China and equipped with high quality ball joint rod end,Website:, connection rod bearing, inner tie rod end, moog tie rod end factory, Tentec Holding Group Limited is always at your service.
The rack end is mounted at the ends of the rack ,and is threaded together with the outer tie rods normally secured by a jam nut, they serve to prevent wheel-steering knuckle spindle vibrations being transmitted to the steering box.There is usually one rack end-tie rod assembly on each side of the vehicle.
MR-130807
EV-159
RACK-END
Rack-End
Other supplier products
|
|
NISSAN STRUT MOUNTING |
Model NO.: 54320-JD00BSize：Supplementary Article/Supplementary Info 2:with ball bearingSpecification: DestraQuantity: 2 pzWeight: 1440 gFitting Pos... |
|
|
HONDA DRIVE SHAFT |
Model NO.: 44010-S84-A50Car Make: HONDAType: DRIVE SHAFTSize: Total Length: 621 mmExt. Teeth, wheel side: 28Ext. Teeth, diff.side: 27Specification:... |
|
|
TOYOTA TIE ROD END |
Type:Tie Rod EndSize:Cone Size: 13.5 mmThread Type: with right-hand threadThread Type: with internal threadThread Size 2: M16x1.5Thread Measurement... |
|
|
Japan Shock Absorber |
As one of the most famous japan shock absorber manufacturers and suppliers in China and equipped with high quality toyota shock absorber,Website:, ... |
|
|
AUDI TIE ROD END |
Type:Tie Rod EndSize:Cone Size: 13.4 mmThread Size 2: M16x1.5RThread Measurement 1: M10x1.25Fitting Position: Front Axle LeftLength: 190 mmCar Make... |
All supplier products
Same products
