Charger Products- Third Party Inspection 100% Quality Control
This check is conducted during the very early stages of the production process (between 0 and 20%). The purpose of the check is to inspect the process parameters and to verify that the final product will meet the desired quality requirements.
We are humans and naturally humans make mistakes, so do factories in China. About half of the factories in China have production issues. If no strict quality check is performed, factories will make according to their standard. That is why to determine the faults earlier is a time and cost saving process,when you figure out the problems when all goods are finished, it will waste lots of time and money to revise. In our experience, we did a quality control while the production just had started, we figured out the color the factory used was totally different from what the customer wanted. This is a major fault. After check up, the factory revised the color immediately. If we performed a quality check after the products are almost finished, this could be a major issue and the shipment will be delayed due to the revision of the issues found at the quality control.
So it is strongly recommended to do a quality check in the early stage of the production process. This quality control is required in China especially to avoid misunderstanding and faults in the further production process.
Send product request
Other supplier products
 |
Inspection service China for multi-functional scissors | At the beginning of production, our inspectors will check on the quality of main components, material and accessories according to clients’ s... |
 |
Micro needle Products- Third Party Inspection 100% Quality Control | At the beginning of production, our inspectors will check on the quality of main components, material and accessories according to clients’ s... |
 |
Pre-shipment Wooden artcraft inspection service for Chinese third-party products | The pre-shipment Inspection takes place when the merchandise is 100% completed, and at least 80% of the products are packed, marked. Our inspectors... |
 |
Keyboard inspection service quality QC on-site inspection | The in-process quality check is designed to provide early warning of quality or other problems arising during production and which may delay shipme... |
 |
Inspection service China for USB drive | Our Service:1. Sourcing ServiceAs an inspection company in China, we have visited many suppliers in China producing different kinds of products. If... |
