Light Steel Keel Roll Forming Machine
Technical Parameters
1 Suitable material Type Galvanized sheet plate
Thickness (mm) 0.85-1.6mm
Tensile strength (Mpa) 235-300Mpa
Width (mm) Refer to profile drawing
Wt of the Coil (t) 3 tons
OD Φ1350mm
ID Φ508 mm/Φ610mm
2 Material of rollers NO.45 with chrome plate
3 Forming Speed (m/min) About20m/minute Not including cutting time
4 Power Source AC380V ,50 Hz, 3 Phase According to buyer’s request
5 Total power About 8KW Depend on final design
6 Dimension (L×W×H, m) See the layout drawing Depend on final design
Working Flow
Decoiling →Guiding →Roll forming → Cutting → Plate to Support Table
Other supplier products
|
|
CNC aluminum extrusion profile with surface treatment |
As well as the CNC aluminium machining,Maxtech also can do the surface treatment for the aluminum extrusion profile.It can make the CNC aluminum ma... |
|
|
285 Ridge Cap Forming Machine |
Technical Parameters1Suitable material Type Colored steel sheetThickness (mm) 0.5-0.55Yield Strength (Mpa) 230-300MpaWidth (mm) 418Wt of the Coil... |
|
|
Aluminum CNC machining service |
As a company with many years of experience in the aluminum CNC machining service industry, Maxtech is committed to providing the best service to ... |
|
|
Roofing machine |
Roofing machine is mainly used in the production of colored steel sheets. The machine is artistically made and transmits smoothly at a low noise.... |
|
|
146 Roll Forming Machine for ridge cap |
Main Technical Parameter1 Suitable material Type Colored coating steelThickness (mm) 0.55Yield strength (Mpa) 345MpaWidth (mm) 4002 Forming Speed... |
All supplier products
Same products
