1.5kg Scaffolding fasteners

• 

2. , Used for fixing steel pipe scaffold with outer diameter of 48mm

considerably longer than is need when the nut has been tightened. This excess length is required to allow the clamp half to be opened even while the nut is retained on the screw. To do so, the screw and nut arrangement engages a slot in the clamp half. This excess length of screw then protrudes into the area around the scaffolding system where it can cause a considerable hazard to people and equipment. For example, an operative walking pass the clamp can snag a part of their body or a part of their equipment on the screw, causing direct injury or indirect injury, perhaps when a loose strap catches on the screw and pulls the operative off balance, or causes an item of equipment to fall towards the ground where it could hit another operative but also at least damage the equipment and other equipment/supplies on the ground. A falling operative could hit one of these clamps in particular the protruding screw and cause considerable harm to him/herself. Furthermore, over time the end of the screw can become damaged and sharp edges or burrs can be generated which further increase the harm that this excess of screw length can inflict on an operative. A member of the public walking past or underneath a scaffolding assembly can inadvertently catch himself on the protruding screw and the responsible authority (operator) must consequently spend a considerable amount of time assessing and mitigating the hazards caused by scaffolding clamps where the public may need to come close to scaffolding. A system which mitigates such a hazard from the start may therefore confer considerable time savings and hazard-related savings on the operator.

More about , please

Other supplier products

	1.5kg Scaffolding fasteners	, Used for fixing steel pipe scaffold with outer diameter of 48mm considerably longer than is need when the nut has been tightened. This excess...
	110mm inner diameter 145mm outer diameter bearing	are a crucialtribologicalcomponent of many types of machinery and exist in a variety of forms and shapes. They can be defined as a component that ...
	1500mm high 20cm width 3mm thick Steel formwork	Steel formwork is used for concrete pouring. In addition to steel formwork, there are wooden formwork, plywood formwork, etc. is widely used in ...
	Mobile Crusher	is mainly used for metallurgy, chemical industry, building materials, hydropower and other materials that often require relocation operations, esp...
	9.5mm-200mm high,5mm diameter drill tail wire	: The head type has flat head / round head / large flat head / The hexagonal head and the tail wire have been tested for tension, torque, screwing ...

Same products

	WPC Railing	Seller: Nanjing Xuhua Sundi New Building Materials Co., Ltd.	When you have a villa or a house, consider using wooden like WPC to build the railing in the yard...
	WPC Pergola	Seller: Nanjing Xuhua Sundi New Building Materials Co., Ltd.	With the super high-performance wpc pergolebeams and the full set of accessories, we have built m...
	WPC Decking	Seller: Nanjing Xuhua Sundi New Building Materials Co., Ltd.	Composite Wood Decking Manufacturer As a professional outdoor wpc deck flooring suppliers, Sundi...
	WPC Cladding	Seller: Nanjing Xuhua Sundi New Building Materials Co., Ltd.	Different types of wall cladding are the surface of the building. Just like the face of a man, tr...
	Traditional Decking	Seller: Nanjing Xuhua Sundi New Building Materials Co., Ltd.	Traditional decking is always welcomed in the park and courtyard, with 70% wood powder, the inexp...