JMZ-T Rubber Vibration Damping Sandwich Mounts
The JMZ-T series rubber sandwich mountsis the new designed model, which is designed especially for the military use. Comparing with the wire rope isolators, this model is small and tinny, which has no worrying about the space limits.
The max static load of the JMZ-T Series anti vibration sandwich mountsis from 1.4 kg to 2.8 kg, which can be specially used in a good deal of precision equipment and system in helicopter, motor, embedded electronics, etc.
The JMZ-T Series vibration damping sandwich mountscan also be used in the very narrow spaces to meet the mountable environmental requirements. This new type friction damper is the very selection for the limits of the space under some special situations.
An earthquake is caused by the motion of the ground which causes the forced vibration of a building that is still at rest on the ground, resulting in internal forces, deformation and displacement in the structure. Vibrational isolation is an isolated earthquake, To isolate or dissipate vibration energy by setting a control mechanism at the base or at a certain location of buildings and structures to avoid or reduce the transmission of vibration energy to the upper structure, reduced the vibration response of the structure, so that only minor motion and deformation of the building can be realized during the earthquake to ensure the safety of buildings. In isolation technology, foundation isolation technology is a hot new technology in the world. The base isolation technology is widely used, it is especially suitable for medium-and low-rise brick-concrete buildings and reinforced concrete buildings.
What is the basic vibration isolation technology
Traditional vibration isolation structure mainly utilizes plastic deformation and energy dissipation of the main structure to dissipate vibration energy after yielding，therefore, the performance requirements of these regions are particularly important. Once these areas have problems due to certain factors, it will affect the vibration resistance of the structure seriously, even produce serious damage. And the foundation isolation is to set a layer of isolation with sufficient reliability between the superstructure of the building and the top of the foundation to separate the superstructure from the foundation, and blocks the propagation of vibration waves to the superstructure, so that the vibration energy of the input structure is absorbed by the energy dissipation elements of the isolation layer, therefore, it will reduce the vibration response of the superstructure greatly, so that ensure the safety of the building.
The basic principle of base isolation technology
According to the experiment, if the period of the structure is prolonged and a large damping is given, it will greatly reduce the acceleration response on the structure. At the same time, large displacements to the structure can be provided by an isolation layer between the bottom of the upper structure and the top of the foundation. In this way, the superstructure will move close to translation during the earthquake, so the safety degree of the superstructure is greatly improved, which is the principle of base isolation. If a damping device is introduced into the structure, the displacement response of the structure can be reduced, and the corresponding acceleration response can also be reduced.
Multi-Application Wire Rope Vibration Isolator
Hoan multi-application wire rope isolatorovercomes the defect of passive wire rope vibration dampers that damping is not adjustable, but because the structure of the mechanical system is complex and the price is expensive, it is mainly used for vibration isolation of some advanced cars or heavy cars.
Send product request
Other supplier products
 |
JGX-0958 Vibration Isolation Dampers Products For Multi Application | Xi'an Hoan's extensive range of stainless steel wire rope isolators and elastomeric shock mounts, most equipment can be suspended successfully. Exa... |
 |
GRY-5A Stainless Steel Vibration Mount for Film/Cinema/Camera/Drone | The GRY-5A marine shipbuilding vibration mount is made by the 30 loops 1.5mm diameter wire rope winded in the two mounting bars. The max static loa... |
 |
GH-30G Anti Vibration Shock Mounts For Military Defense | The max shock of the GH series shock and vibration mounts is 30G, which is specially used for military or defense. Or any other conditions require ... |
 |
JMZ-1-2.0B Rubber & Metal Anti Vibration Mount | JMZ-1-2.0B rubber vibration absorberbelongs to the JMZ-1 series. It adopts the structure of double spring and special friction plate. It has good i... |
 |
JMZ-1-3.0A Rubber & Metal Anti Vibration Isolator Mounts | With the rapid development of modern industrial engineering, the various manufacturing machine, transportation machine are all developing to high s... |
Same products
|
|
Wylie Rear Camera Test Flex Cable for iPhone X-12 Pro Max | Seller: Phonefix | Wylie rear back camera test extension flex cable for iPhone X-12 Pro Max. Wylie iPhone rear camer... |
 |
JCID Non-Removal Front Camera Tag-on Repair Flex Cable for iPhone 14-15 pro max | Seller: Phonefix | JCID Non-Removal Front Camera Tag-on Repair Flex Cable for iPhone 14-15 pro max. JCID 14-15 Serie... |
 |
SATELLITE COMPONENTS PRODUCT | Seller: Chang Guang Satellite Technology Co., Ltd. | Cubesat Componentsand Satellite ComponentsProduct It is used for mechanical connection between... |
 |
4mm Orange Circular Cable 3 Core+ Earth 0.6-1kv | Seller: Guangdong Jinlianyu Cable industrial Co.,Ltd | 4 mm orange armoured cableare widely used in Australia and New Zealand marktet following the stan... |
 |
GYFXBY Flat Fiber Optic Cable | Seller: Hangzhou Tuolima Network Technologies Co., Ltd | The structure of flat fiberoptic cable is to sheath single-mode or multi-mode optical fiber into ... |
