T50 accessories-good easy to pull
1.Made of steel wire rope
2.Density: 8（g/m）
3.Rod diameter 2（mm）
4.Temperature - 800 to 800 (℃)
5.Traction tension failure 800（kg）
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
Cable Drum Rotators 6tons made in China Braked Drum Stand |
DP014-5: Rated Load-5T, apply for drum dia 600-2400mm, application of disc width-below 1600mm, shaft diameter-76mm, weight-95kg DP014-5: Rated Loa... |
|
|
10mm x 490' Duct Rodder Fish Tape / Wire Cable Rod Fishtape Puller |
Fiberglass duct rodder features 1.Light weight,durable,resistance to acid,alkali,aging resistant,corrosion resistant. 2.High tensile strength and b... |
|
|
Three Wheel Corner Pulley |
1.Application: Used for guiding cable to turn and set free. and used for setting power cable and communication cable in trenchers or on ground. 2.... |
|
|
Cable pulling equipment straight cable rollers for cable installation |
The cable roller can protect the cable, at the same time, cable block also can effectively reduce the friction of the cable, improve the constructi... |
|
|
HD-1095/06120 large square mechanical crimping pliers |
Manual type crimping pliers：Using high and low two levels of plunger pump driven design, operation fast and effort; System is equipped with safety ... |
All supplier products
Same products
