Single lattice weave cable pulling grips
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Other supplier products
|
|
large multihole cable jacks |
Cable jacks according to usage is also referred to as the cable bracket, wire shaft disc rack, cable bracket. The form can be divided into, hydraul... |
|
|
K22 German imports klauke mechanical pressing line clamp |
Manual type crimping pliers:Using high and low two levels of plunger pump driven design, operation fast and effort; System is equipped with safety ... |
|
|
NNEP Glass fiber reinforced plastic cleaning rod |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
|
|
NBN TRACE WIRE COPPER FIBREGLASS RODDER FISH SNAKE CABLE PULLER |
Purpose: Cable puller is mainly used for in building installation wiring duct drawing guide line, as well as the protection communication cable, po... |
|
|
Fibreglass Duct Rodder Fish Tape on Frame & Reel for NBN Rodalong |
1. The model steel and wire one-piece fusion, more wear-resisting, safe load of 300 kg。 2. Spring steel wire head, can rotate 360 degrees, can be b... |
All supplier products
Same products