L06S50 Tracing Duct Rod
1. It is easy to lead, can be used in narrow passage and limited space 2. A lot of the handle, the user can better control to use 3. Self expansion casing, make the steel wire bending is very convenient 4. The design of the hook is convenient and artistic effect 5. We adopt imported steel wire material, durable and corrosion protection 6. This kind of imported steel wire material, make the line more straight and full of elasticity, into a tube and shell, not blocked or bend down, in and out is very convenient.
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
Drum Roller Rails Cable Drum Rotators Coil unwinder / roller |
DP028-2: rated load 2T, thickness of bottom plate-6mm, dia of bottom plate-800mm, weight- 50kg DP028-3: rated load 3T, thickness of bottom plate-6... |
|
|
Smooth wire mesh grips & Hoisting grip & Stainless steel cable sock |
Cable Socks / cable pulling grip mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off const... |
|
|
REC-5510 Plug-in crimping plier from Japan |
1 The head can rotate 360, two-speed double-acting hydraulic equipment by design 2 When the pressure to complete stop of the motor and automaticall... |
|
|
International fiberglass 5/16''duct rodder |
Available in lengths of 100m,200m and 300m with a wheeled cage for easy transport. The unit is available with meter markings and comes standard wit... |
|
|
L0420 FISH SNAKE CABLE PULLER 4.5MM X 20MTS |
Purpose: Cable puller is mainly used for in building installation wiring duct drawing guide line, as well as the protection communication cable, po... |
All supplier products
Same products
