Cable Pulling Grips/side pull steel wire mesh for cable
Pulling grips Styles and Applications
1.Medium duty pulling grips are double weave for added strength with greater mesh contact on the cable to handle longer or heavier pulling jobs.
2.light duty pulling grips are single weave with a flexible eye for easy attachment to a pulling line. Cable Pulling Grips are used in general underground electrical construction where pulling tensions are low.
3.slack pulling grips are made of galvanized steel and come in three styles with a single offset eye for easy attachment to a pulling line. cable socks Closed, when the cable end is accessible, split lace and rod closing when cable end is not accessible. Cable grip are used in pulling slack for final placement of underground cable after Cable Pulling Grips has been pulled and longer mesh for higher pulling loads where space is not restricted.
Other supplier products
|
|
L0410 SNAKE CABLE DUCT PULLER NBN |
Medium strength, medium flexibility, and good abrasion resistance. Used in garage doors, winches, and tie down applications. Not intended for use i... |
|
|
SKGF-2/3/5 bolt type wire grip, anti-twist rope wire grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to ... |
|
|
LOPG-2 Aluminum alloy cable grip |
Easy to Use• Versatility—All models are rated for a variety of wire sizes and types, so fewer grip changes are required.• Grips ope... |
|
|
SKDP-1 eccentric wheel earth wire grip,earth wire rope clips |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
|
|
Equipment for the cable depot Cable-drum take-off rollers |
Purpose: applicable to the line of the line construction in the development and release of the disc Features: the exhibition release speed is stabl... |
All supplier products
Same products
