Cable pulling Grips made by high grade galvanized steel
Closed weave hoisting grips feature a closed-mesh design which simplifies installation over traditional split, lace-up style grips. The unique design allows the pre-laced hoisting grip to slip over an unterminated end of coax. The grip securely tightens when pulled, providing an effective means to hoist coax into position and to provide additional support for the coax once in place.
Other supplier products
|
|
single loop, single eye cable wire grips |
mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off construction, is the electric power (o... |
|
|
EZ-85 Battery power Cable Cutter |
Li-ion batteriesdo neither have a memory effect nor self-discharge. Even after long periods of non operationthe tool is always ready to operate. In... |
|
|
HT-131H open type hydraulic pliers |
according to the frequency of daily use, crimping pliers, pin, shaft and bearing contact surfaces should be timely daub lubricating oil; Crimping p... |
|
|
hand manual hydraulic cable cutter,electric hydrauliccutter |
Manual release in case of need. Item No:THC-85 Cutting force: 60KN Cutting range: dia 85mm Cu/Alu cable and Armoured Cu/Alu cable. Stroke: 86mm Len... |
|
|
factory direct sales insulating rodder |
Fiberglass duct rodder features 1.Light weight,durable,resistance to acid,alkali,aging resistant,corrosion resistant. 2.High tensile strength and b... |
All supplier products
Same products
