L06S20 sewer pipe inspection tools
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
Hydraulic cable dispenser, more save labour |
Large hydraulic line frame is cable stand in amplifying tonnage cable tray bracket, divided into 8 tons, 10 and 15 tonnes for placement of cable tr... |
|
L0750T FRP snake rod for communication and construction |
1.Strong: maximum tensile damage coefficient under 700 kg (please don't exceed 700 kg, in order to avoid broken wire damage body), security departm... |
|
Cable pulling equipment straight cable rollers for cable installation |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
|
cable drum jacks apply for Multiple wire disk specifications |
DP011-3: Rated Load-3T, apply for drum dia 700-2100mm, application of disc width-below 1500mm, shaft diameter-60mm, weight-75kg DP011-5: Rated Loa... |
|
SKD35-50 earth wire grip,earth cable grip,steel strand cable grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
All supplier products
Same products