T30 quick pulling wire 30m with sleeve
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
L06S10 wall Tracing Duct Rod |
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secon... |
|
300' length 3/16" Mini-Cobra Rod |
Medium strength, medium flexibility, and good abrasion resistance. Used in garage doors, winches, and tie down applications. Not intended for use i... |
|
hydraulic lifting cable stand |
Hydraulic Cable Drum Jacks, Cable Jack Stand is used for supporting the cable drum when laying cable, With the trapezoidal structure, hydraulic cab... |
|
Cable roller with ground plate |
Cable block is generally used in the ground and cable bridge frame protection of high voltage cable. The cable roller can protection 180 mm diamete... |
|
Diesel motor cable winch |
Powered winches are the construction tools of erecting electric circuits of high pressure electric transmission in the sky and laying eletrical cab... |
All supplier products
Same products